K at present we will exhibit you learn how to replace the bottom plate of a wall so you may also run into this quite a bit where you get some wooden on the backside plate of your stud wall that’s either rotted out from water or for termites now we all know we had termites in here but this down right here we suspect could have been from water so that you would see if we push on it with a foot there and spot how it simply it is all marsh so more commonly between the water and the termites this bottom plate has simply been thoroughly disintegrated so we will must pull this out and replace it however you traditionally were questioning good how do you try this after it’s all been put up and is there a load on it or anything wrong as that you can inform what we seem up at the prime this is not a load-bearing wall due to the fact the load-bearing comes this way off of this wall this wall is the burden-bearing wall this wall just isn’t there may be nothing above the the top plate on those there so what we ought to do right here is simply start to cast off the disintegrated fabric but also we have got to use the sawzall to get beneath these studs right here and recollect there’s nails pointing up into these studs from after they laid this down on the bottom and developed this and we additionally acquired lucky right here that the Builder on no account secured this bottom plate to the floor there is no anchor there isn’t a nail or ain’t some thing whereas if you seem at this wall over here you will find we shot them in with a some of the nail guns there and say the remm set so what we ought to do what were right here then is we’re gonna slice underneath there may be almost always two nails in each stud with the sawzall so we will show you that method correct now so this is the first one and you will find it goes fairly quick if in case you have the correct blade to your saws on for metallic for nails and also you just do all the relaxation of the studs in that equal trend here on the backside of that plate you could see just how badly it was once disintegrated this was once undoubtedly from do away with termites we saw termite mud in there tubes going up the inside of the drywall on the other part nevertheless it’s like this the whole means down and then right here you’ll find more of the termite exercise on the baseboard that we pulled off and so as we pull out the backside plate you will see what we’ve got carried out is we have now put these blocks below them now this isn’t a load-bearing wall so we do not have got to build up ceiling braces or some thing first so we have simply stuffed these beneath right here and if we need to add extra shims to get these up slightly greater we will be able to do this however proper now these are rather unfastened so I consider we will be okay after we get the brand new bottom plate it should be in a position to slide in beneath it lovely just right here one can find we eventually eliminated the backside plate all of the studs at the moment are resting on their spacers here and we’re now going to reduce the new bottom plate and slide it into position k so here we’re on the other part of the wall we’re starting to insert this new backside plate right here what we’re gonna do is practically push it in against these blocks right here they are going to push them out from beneath the studs and the bottom plate will take their position so that is what we’re doing here [Music] all right so here is the base plate already installed now we’re just going to must toenail in place that suggests we will take our body nailer and we’re going to are available in at an perspective like this with the nails have run them straight in here and shoot them in and they’re going to go and then diagonal by means of the stud and by means of the bottom plate like that